Fosroc Lokfix S – 0.5 Ltr

325

Lokfix S is a two-component polyester resin anchoring grout, meeting the requirements of BS EN 1504-6: Anchoring of reinforced steel bars. ( 0.5 LTR)

 

300 in stock

Description

Fosroc Lokfix S

-Polyester resin anchoring grout

Lokfix S is a two-component polyester resin anchoring grout, meeting the requirements of BS EN 1504-6: Anchoring of reinforced steel bars.

Lokfix S is produced in two versions. The two versions of Lokfix are all pre-measured, two-part, filled polyester resin grouts. After hardening, the grout produces anchorages of consistent reproducible values. The versions are:
Lokfix S – used where hole diameter is less than 25 mm greater than the bar diameter.
Lokfix P – used in overhead or horizontal holes where bar/hole relationship conforms to Lokfix S. The thixotropic nature of Lokfix P reduces the flow of grout out of the hole.

Main uses:
Supplied in pre-measured quantities, the material cures quickly to give consistent, high-performance anchorages. The two versions of Lokfix available are :

Lokfix S25: Pourable grade, 25 minute gel time at 20°C for use in vertical down holes where the hole is 8 to 40 mm greater in diameter than the bar.

Lokfix P25: Thixotropic grade, 25-minute gel at 20°C for use in overhead or horizontal holes where the hole is up to 25 mm greater in diameter than the bar. The thixotropic nature of Lokfix P25 reduces the flow of grout out of the hole.

 

Advantages:

  • Rapid strength gain.
  • Vibration resistant.
  • Corrosion-resistant.
  • Non-expansive.
  • Can be placed underwater

Uses:

Lokfix mix and place grouts are used for high strength corrosion resistant anchoring of bolts and bars from 12-51 mm diameter into concrete, rock, masonry or brickwork where high speed of installation and early application of load is required. Permanent installation of reinforcement starter bars, foundation bolts, base plates, balustrading, barriers and safety fences, railway tracks, tie-back anchors, reinforcement dowelling abutments, ground anchors for towers, cranes, dock sills etc.

Estimating:

Pack sizes

Lokfix S The pack consists of a can of resin and a plastic bag of hardeners.

The volume of mixed components: 1.2 litres.

Lokfix P The pack consists of a can of resin and a plastic bag of hardeners.

The volume of mixed components: 1.2 litres.

Fosroc Solvent 105 – 4 and 25-litre containers.

Additional information

Weight 2 kg
Dimensions 255 × 200 cm

Reviews

There are no reviews yet.

Be the first to review “Fosroc Lokfix S – 0.5 Ltr”

Your email address will not be published. Required fields are marked *

X